| Customization: | Available |
|---|---|
| After-sales Service: | English Manual, Installation Videos, Engineer Team |
| Warranty: | 12 Month |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Single non-positioning label maximum output | 50 pcs /min (depending on bottle and label size) |
| Label bottle diameter | Ф20-90mm (other models need to be adjusted) |
| Power | 50W |
| Power supply | 220V±5%50HZ |
| The ambient temperature | 5-45ºC |
| Relative humidity | 15-90% |
| Overall dimensions (length × width × height) | 640×350×460mm |
| Weight | 30kg |
| Output speed | 3-15m/min (10-15bpm) |
| Labeling accuracy (excluding package and label errors) | ±0.5mm |
| The minimum length of a label | 10mm |
| Fault | Causes and solutions |
| No label coming out | The position of the microswitch is incorrect. Adjust the position of the microswitch |
| The microswitch goes wrong. Replace the microswitch | |
| The knurled wheel does not compress the label belt and slips when pulling the label. Tighten the adjustable screw of the drawbar | |
| The power switch is not turned on. Turn on the power switch. | |
| More than one label coming out | The optical fiber base is incorrectly positioned or the label paper does not pass through the optical fiber base. Adjust the position of the optical fiber base |
| Sensor failure. Adjust or replace sensors according to item 3.2 of the manual | |
| Incorrect axial position of the label | The front and rear positions of the stop rods are not positioned. Lock the stop lever |
| The label is not located on the label stripper plate. Adjust the label position | |
| The bottom of the bottle is not attached to the bar. | |
| Can't be labeled | The reserved label is not long enough. Increase the reserved label length. |
| The surface of the adhesive is not sticky enough to the label or the humidity is too high | |
| The bottle roller does not press down on the attached bottle, and the attached bottle does not roll | |
| The label wrinkles after being attached | The reserved label is too long. Reduce the reserved label length |
| There are sundries on the surface of the bottle. | |
| The distance between the label stripper plate and the rubber roller is too close. Adjust the distance properly | |
| The label is not properly compressed by the pressure plate. The label which peeled out of is not straight. Adjust the pressure plate to properly press the label | |
| The beginning and end of the label are misaligned after the roll is affixed | The stripper plate is not parallel to the axis of the bottle to be affixed. Adjust the roller and the position of the stripper plate so that the bottle holder roller and the stripper plate are parallel to the labeled soft roller. |
| The label belt swings back and forth when it is tilted or pulled. Fasten the guide ring to prevent the label from swinging back and forth. | |
| The error in the diameter of the labeled area of the object is too big. It is caused by the object itself | |
| The distance between the label stripper plate and the bottle body is too far or the W is slightly touched. The normal distance is about 5-10mm | |
| Stripper plate The mounting plate is not secured tightly and shakes during labeling. Resetting screw | |
| The bottle is not clean or dry. Replace it with a clean and dry bottle |
){kind=link}